AVL DynoPerform / 100 SIMULATION SOLUTIONS TEST SYSTEM SOLUTIONS Electrification atterette Eotorette oerElectronic ette oonent ette onteirtal tete Enineette Enoine ette ealieette rielineette elane ette Eiionette anertification eicleette acinette TESTING EQUIPMENT Dynamometers and Actuators icleete etellecanic anontroloo eiaonitionin ontion eareent nectionetin otion eareent Eiionnali aneareent neicle eareent TESTING EQUIPMENT SIMULATION TOOLS TESTING TOOLS CUSTOMER SERVICES Eddy current dynamometers in the AVL DynoPerform series are equipped with drum rotors. An adjustment of the air gap is not necessary. A C current ows through the ecitation coil. This creates a variale magnetic fi eld that is dependent on the ecitation current. The magnetic fi eld of the rotating rotor creates eddy currents at the surface of the cooling chambers. This converts the mechanical energy of the engine into thermal energy. The energy is absorbed by the cooling water which can be retroactively cooled via a cooling tower, as it is the case for the cooling water for the combustion engine. TORQUE MEASUREMENT The eddy current dynamometer is a cradled dyno. The reaction force of the brake torque is measured with a strain gauge-based load cell. The measuring accuracy is in uenced y the linearity of the load cell and the hysteresis of the dyno. The torque measuring system is calibrated by load beams and dead weights. The measuring error of the load cell can e compensated y the measuring amplifi er. APPLICATION Cost-effective dynamometer for tests in R&D, quality control and endurance • Steady-state and transient applications • R&D for engines and components • Tests for fuel and lubrication oil BENEFITS AT A GLANCE • Excellent full-range torque and speed control stability • No axial forces on the shaft bearings due to drum rotor design • No air gap adjustment required • Very fast loading and unloading thanks to an IGBT full bridge power unit with a 4-quadrant PWM controller (substantially faster than a thyristor bridge power unit) • High permissible coupling weights LOAD UNIT FOR ENGINE TEST CELLS Using the power unit LSE 410 for eddy current dynamometers, very quick load changes are achieved due to the modern IGBT technology with PWM control
Solutionskatalog_2017_E
To see the actual publication please follow the link above